Cody
Vice President
Staff member
Administrator
Moderator
Content Moderator
Board Member
Supporting Member
Couple questions for y'all that have made shaker doors before.
1) Where did you source your plywood inlays? The only place that I've found anything close to 1/4" is Rockler, which is actually .23" thick, and costs $30 for a 24"x 60" sheet. That will work just fine, I was wondering if I could find something cheaper though.
2) Did you use spacers in the rails to allow the inlay to expand?
1) Where did you source your plywood inlays? The only place that I've found anything close to 1/4" is Rockler, which is actually .23" thick, and costs $30 for a 24"x 60" sheet. That will work just fine, I was wondering if I could find something cheaper though.
2) Did you use spacers in the rails to allow the inlay to expand?